enLanguage

Regular Maintenance Checklist For Closed Circuit Cooling Towers

Jan 10, 2026

Leave a message

Regular Maintenance Checklist for Closed Circuit Cooling Towers

 

 

Oasis Bingfeng Closed-Circuit Cooling Tower

I. Daily Inspection (Each day or shift)

Visual and Auditory Check: Observe if operation is smooth; listen for abnormal vibration or noise.

Water Quality and Level: Check the water level in the spray water (external circuit) collection basin; observe if the water is clear and free of obvious impurities or foam.

Instrument Parameters: Record key operational data such as inlet/outlet water temperature, pressure, and current.

Leak Check: Quickly inspect the equipment and pipe connections for any signs of leakage.

 

 

II. Weekly Maintenance

Cleaning: Remove floating debris (e.g., leaves, plastic) from the surface of the collection basin.

Nozzle Check: Observe if spray water distribution is even to preliminarily identify any blockages.

Fastening Check: Manually check visible bolts and terminal connections for looseness.

Oasis Bingfeng Evaporative Condenser

 

Closed-Circuit Cooling Tower Manufacturer

III. Monthly Maintenance

Deep Cleaning of Spray System: Clean the spray water filter (e.g., Y-strainer).

Nozzle Unclogging: Remove and clear some spray nozzles to ensure unobstructed water flow and even distribution.

Electrical Check: Tighten electrical connection points in the main power supply and control cabinet; check the status of the electrical control system.

Fan Check: Inspect fan blades for surface cleanliness; manually rotate the fan to confirm smooth movement.

 

IV. Quarterly Maintenance

Coil Cleaning: Use a low-pressure water gun (pressure ≤ 0.3MPa) to rinse the external surface of the coils from top to bottom, removing dust, pollen, algae, and other deposits.

Drive Component Check: Check and adjust fan belt tension (if belt-driven); check gearbox oil level and quality.

Structural Inspection: Inspect the tower structure and connectors for corrosion or looseness.

Water Quality Testing and Analysis: Sample and test spray water and internal circulating water (if applicable); adjust the water treatment program based on the results.

Air Cooler Manufacturer

 

Oasis Bingfeng Closed-Circuit Cooling Tower

V. Annual/Seasonal Maintenance (Typically during seasonal shutdowns)

Comprehensive Chemical Cleaning: Perform chemical cleaning on the spray water system and internal circuit (as needed) based on water conditions to thoroughly remove scale and biological sludge.

Coil Inspection and Leak Test: Conduct a pressure test or inspection on the heat exchanger coils to ensure no leaks. Focus on welds and elbow joints.

Bearing Maintenance: Clean the bearings of fans and pumps; replace grease or lubricating oil.

Comprehensive Corrosion Protection: Inspect the anti-corrosion coating on the tower body and frame; grind and repaint any corroded areas.

Instrument Calibration: Calibrate sensors and instruments for temperature, pressure, flow rate, etc.

Safety Device Testing: Test the effectiveness of safety devices such as vibration switches and overload protection.

Internal Cleaning: Completely drain and clean sludge from the bottom of the collection basin and water tank.

 

VI. Maintenance for Special Climates or Operating Conditions

Before Winter: Focus on implementing freeze protection measures (draining, adding antifreeze, checking heat trace cables).

After Sandstorm or Pollen Season: Immediately increase the frequency of rinsing the external coil surfaces.

After Long-Term Shutdown: Before restarting, perform a comprehensive inspection and cleaning according to the "Annual Maintenance" standard.

Oasis Bingfeng Evaporative Condenser

 

 

 

Send Inquiry